How to choose the right iron remover
The iron remover can be divided into many kinds of iron removal methods according to its different use occasions, environment and iron removal requirements. Therefore, when selecting the iron remover, the iron remover should be correctly selected according to the requirements of the impurity removal rate, the iron content of the material, and the on-site working environment. In order to give full play to the performance of the iron remover and achieve the ideal iron removal effect. The following is to share several points for the choice of iron removal:
1. When the impurity iron removal rate is required to be higher, iron removal equipment with different working modes can also be used, such as permanent magnet roller for the head of the belt machine, and belt type iron removal device for the middle of the belt machine.
2. When the material layer is thick and the material particle size is large, it is appropriate to choose super magnetic iron remover; Or large one or large two super models choose ordinary iron remover; Can also be multistage iron removal; Multistage iron removal should be used as far as possible to install iron in the belt head.
3, the site environment dust is more serious, should choose a fully closed structure of the iron remover.
4, when the power capacity is insufficient, permanent magnet remover should be selected.
5, the material contains more miscellaneous iron, should choose self-unloading iron remover.
6. When the iron remover is installed in the head of the belt, due to the inertial force of the material, it is in a loose state when leaving the belt, which is conducive to iron removal. If the drive of the head of the belt is changed to a non-magnetic material, the iron removal effect will be better.
7. Belt conveyor bandwidth below 1400mm is recommended to use belt permanent magnet iron remover, belt conveyor bandwidth above 1600mm is recommended to use electromagnetic iron remover.
8, when the use of multistage iron removal, the removal of iron suction after the stage should be higher than the removal of iron suction before, otherwise, it will remove the low iron removal effect.
9. When the site environment is special and the situation is complex, the user can carry out special design to meet the actual working conditions.
10. The hanging device of the iron remover should be selected according to the actual needs of the site working environment, and the hanging position and environmental conditions of the iron remover should be determined before purchase.